Designed by JayBo, Inspired by SMM, this is Wismec’s
first Drip Tank Hybrid featuring the new and exciting Stainless Steel
NotchCoil. This Atomizer is the first to utilize an Open Wicking System, a
combined Top Airflow Juice Plug and a Solid Leak-proof Sleeve Design. Removing
the glass sleeve from the deck exposes the build area making it completely
accessible and easy to install both cotton and coils. Removing the Top Airflow
Cap simultaneously exposes the fill port, allowing the user to easily refill
the Atomizer without alerting their airflow settings.
Specifications:
Material - Stainless steel & glass.
Size: Height 46.25mm - Diameter 22mm.
Color – Stainless.
Threading – 510.
Contains:
1 piece Theorem Atomizer.
2 pieces Airflow Control Rings (single and dual).
1 piece Stainless Lined Glass Sleeve.
1 piece Glass Sleeve.
2 pieces NotchCoil with Cotton.
3 pieces Silicon O-rings (Cyan).
4 pieces Screws.
1 piece Hex Key 1.25mm Drive (0.05in).
1 piece User Manual.
Important Notice
Sub-Ohm: Sub Ohm vaping is inherently dangerous and injury can occur if certain
safety guidelines are not always followed. You must be also ensuring that your
batteries can handle sub ohm atomizers and coils. If you're using a regulated
mod, make sure it can handle the amps.
Sub-Ohm coils are for experts, not average or beginner
vapers with no multimeter or knowledge of how to use a meter, or when a meter
must be used, or how electronic devices work. If the coils are not built or
tested correctly this can irreparably damage your devices i.e. Mods, Batteries
Tanks etc. and may also cause personal injury. These materials cannot safely be
used by the inexperienced or those without basic knowledge of electronics,
ohm's law, and amps!
Sub-Ohm coils will only work on a mechanical mod or a
regulated mod capable of firing sub-ohm atomizers and coils.
This is because:
A coil MUST be tested carefully with a calibrated meter before it is used.
If it is not tested it may damage the device it is used on.
Faulty wicks/coils WILL blow electronic devices.
New coil/wick units must be tested and then used first on a strong basic
electrical APV such as a Silver Bullet, that will not be destroyed by a short
circuit.
No new coil/wick assembly should be used on an electronic device until known to
be safe.
These items destroy electronic devices if faulty.
These items have inherent risks and may go faulty at any time even if they were
originally in good working order. The owner bears the cost of equipment damaged
as a result.
Make sure that your battery is either removed from your mod, or your mod is
adequately locked when you are building your coils.
Mods:
"Mods" are by definition a modification to a
design. There is a degree of risk inherent with any device that uses lithium
type batteries. Some of the dangers are short-circuiting, reverse battery
issues, and exceeding voltage limitations. Understanding how to handle and care
for Lithium type batteries is very important and should always be practiced.
Lithium type batteries are very sensitive to charging characteristics and may
explode or flame if mishandled.
This is an advanced user device which is recommended
for use by experienced vapers only. It requires you to have a strong technical
knowledge of mods in order to use this device properly, and safely. Indy Vapor
Shop will not be held responsible or liable for any injury, damage, or defect,
permanent or temporary that may be caused by the use of any battery.
Indy Vapor Shop is not responsible for any device
malfunctioning due to use by an inexperienced vaper who does not have the
knowledge and understanding of how to use, and properly rebuild advanced
e-cigarette devices.
Please have a basic understanding of the batteries you
are using and how to care for them properly. Read the information found at: Battery
University before purchasing.
It is important to carry batteries properly, recharge
properly, and dispose properly.
Since we have no control over how a buyer uses the
product; no guarantee, warranty, or return privilege will apply. The
manufacturer may offer a limited warranty. Buyer shall be responsible for
returning the product to the manufacturer. We regret having to strictly enforce
this policy. The use of DIY liquid, improper chargers, modified atomizers, and
general abuse of the product has made it necessary.
Please do not order if you do not
understand and accept these terms.