The
Joyetech eGo One CL-Ti and eGo One CL-Ni heads are the newest revolution in
vaping technology. Both units allow for temperature control using either
titanium or nickel as heating wire. Wicked with organic cotton, expect flavour
to be top notch without any dry burns due to the composition of the wire
preventing a situation as such. Located at the very bottom of each coil head is
a gold plated pin for maximum conductivity.
Read!
These
coils are specifically designed to be used with advanced devices furnished with
circuit boards capable of controlling coil temperature. Using with any other
device can result in battery explosion and injury!
CL-Ti
Head 0.4 Ohm:
The
Joyetech eGo One CL-Ti Titanium Atomizer Coils can also accommodate temperature
limiting and sensing devices. Therefore, the actual temperature of the coils
can be controlled.
Coil
Material: Titanium wire from the USA.
100%
Organic Cotton.
Resistance:
0.4 Ohms.
Temperature
Control Compatibility: Yes. Works under the VT-Ti mode (temperature control).
Temperature
recommended: 450-500˚F.
Compatible
With: Joyetech eGo One Clearomizer / Joyetech eGo One Mega Clearomizer.
CL-Ni
Head 0.2 Ohm:
Designed
for use only with temperature controlled mods. The Joyetech eGo One Ni
Replacement coils are made of Ni-200 (Nickel) resistance wire and are wicked
with 100% organic Japanese cotton. Utilization of gold plated connectors improves
conductivity and resistance accuracy. oil Material: Nickel wire from the USA.
100%
Organic Cotton.
Resistance:
0.2 Ohms.
Temperature
Control Compatibility: Yes. Works under the VT-Ti mode (temperature control).
Temperature
recommended: 500-550˚F.
Compatible
With: Joyetech eGo One Clearomizer / Joyetech eGo One Mega Clearomizer.
Important Notice
Sub-Ohm: Sub Ohm vaping is inherently dangerous and injury can occur if certain
safety guidelines are not always followed. You must be also ensure that your
batteries can handle sub ohm atomizers and coils. If you're using a regulated
mod, make sure it can handle the amps.
Sub-Ohm
coils are for experts, not average or beginner vapers with no multimeter or
knowledge of how to use a meter, or when a meter must be used, or how
electronic devices work. If the coils are not built or tested correctly this
can irreparably damage your devices i.e. Mods, Batteries Tanks etc. and may
also cause personal injury. These materials cannot safely be used by the
inexperienced or those without basic knowledge of electronics, ohm's law, and
amps!
Sub-Ohm
coils will only work on a mechanical mod or a regulated mod capable of firing
sub-ohm atomizers and coils.
This
is because:
A coil MUST be tested carefully with a calibrated meter before it is used.
If it is not tested it may damage the device it is used on.
Faulty wicks/coils WILL blow electronic devices.
New coil/wick units must be tested and then used first on a strong basic
electrical APV such as a Silver Bullet, that will not be destroyed by a short
circuit.
No new coil/wick assembly should be used on an electronic device until known to
be safe.
These items destroy electronic devices if faulty.
These items have inherent risks and may go faulty at any time even if they were
originally in good working order. The owner bears the cost of equipment damaged
as a result.
Make sure that your battery is either removed from your mod, or your mod is
adequately locked when you are building your coils.
Mods:
"Mods"
are by definition a modification to a design. There is a degree of risk
inherent with any device that uses lithium type batteries. Some of the dangers
are short-circuiting, reverse battery issues, and exceeding voltage
limitations. Understanding how to handle and care for Lithium type batteries is
very important and should always be practiced. Lithium type batteries are very
sensitive to charging characteristics and may explode or flame if mishandled.
This
is an advanced user device which is recommended for use by experienced vapers
only. It requires you to have a strong technical knowledge of mods in order to
use this device properly, and safely. Indy Vapor Shop will not be held
responsible or liable for any injury, damage, or defect, permanent or temporary
that may be caused by the use of any battery.
Indy
Vapor Shop is not responsible for any device malfunctioning due to use by an
inexperienced vaper who does not have the knowledge and understanding of how to
use, and properly rebuild advanced e-cigarette devices.
Please have a
basic understanding of the batteries you are using and how to care for them
properly. Read the information found at: Battery University before purchasing.
It is important to
carry batteries properly, recharge properly, and dispose properly.
Since we have no
control over how a buyer uses the product; no guarantee, warranty, or return
privilege will apply. The manufacturer may offer a limited warranty. Buyer
shall be responsible for returning the product to the manufacturer. We regret
having to strictly enforce this policy. The use of DIY liquid, improper
chargers, modified atomizers, and general abuse of the product has made it
necessary.
Please do not order if you do not
understand and accept these terms.