The Hannya RDA by Blitz Enterprises is one of the
most innovative atomizers released in the Marketplace and is different from
your typical rebuildable. Without any posts, your coil leads go straight down
into four holes on the deck. This insures that coils stand out when the posts
are not in the way. The positive "post" in the middle section is
surrounded by a PEEK insulator while the other two lead holes are negative
"posts". Four holes are integrated into the base of the unit for maximum
use of build space and four holes on the circumference of the base where the
screws are tightened down to make a secure connection on the coil leads. This method ensures a high level of coil
conductivity and extra resistance. Seven air holes on each side measuring 2mm
in diameter each with adjustable airflow features allow for dual or single coil
builds which contribute to the massive amounts of airflow. A Delrin Honeycomb filter simultaneously
reduces spit back while providing airflow disruption, connecting into a competition
wide bore tip. The chuff top is held tightly by an O-ring.
510 drip tips will not fit this rebuildable.
Features:
22mm Diameter.
4ml Juice Well.
Stainless Steel Construction.
Pyrex Glass Reinforcement.
Curved Design Delrin Wide Bore Drip Tip.
Innovative Post Less Design.
Two Positive Terminal Holes Surrounded by PEEK Insulator.
Two Negative Terminal Holes.
Single and Double Coil Configuration.
Lightning Bolt Air-Slots.
Adjustable Airflow Control.
Convenient Top-Fill Design - Simple Drip Tip Twist.
Copper-Plated 510 Connection Pin.
Contains:
Hannya RDA.
Allen Key.
2 Additional Screws.
Replacement O-Rings.
Important Notice
Sub-Ohm: Sub Ohm vaping is inherently dangerous and injury can occur if certain
safety guidelines are not always followed. You must be also ensuring that your
batteries can handle sub ohm atomizers and coils. If you're using a regulated
mod, make sure it can handle the amps.
Sub-Ohm coils are for experts, not average or
beginner vapers with no multimeter or knowledge of how to use a meter, or when
a meter must be used, or how electronic devices work. If the coils are not
built or tested correctly this can irreparably damage your devices i.e. Mods,
Batteries Tanks etc. and may also cause personal injury. These materials cannot
safely be used by the inexperienced or those without basic knowledge of
electronics, ohm's law, and amps!
Sub-Ohm coils will only work on a mechanical mod
or a regulated mod capable of firing sub-ohm atomizers and coils.
This is because:
A coil MUST be tested carefully with a calibrated meter before it is used.
If it is not tested it may damage the device it is used on.
Faulty wicks/coils WILL blow electronic devices.
New coil/wick units must be tested and then used first on a strong basic
electrical APV such as a Silver Bullet, that will not be destroyed by a short
circuit.
No new coil/wick assembly should be used on an electronic device until known to
be safe.
These items destroy electronic devices if faulty.
These items have inherent risks and may go faulty at any time even if they were
originally in good working order. The owner bears the cost of equipment damaged
as a result.
Make sure that your battery is either removed from your mod, or your mod is
adequately locked when you are building your coils.
Mods:
"Mods" are by definition a modification
to a design. There is a degree of risk inherent with any device that uses
lithium type batteries. Some of the dangers are short-circuiting, reverse
battery issues, and exceeding voltage limitations. Understanding how to handle
and care for Lithium type batteries is very important and should always be
practiced. Lithium type batteries are very sensitive to charging
characteristics and may explode or flame if mishandled.
This is an advanced user device which is
recommended for use by experienced vapers only. It requires you to have a
strong technical knowledge of mods in order to use this device properly, and
safely. Indy Vapor Shop will not be held responsible or liable for any injury,
damage, or defect, permanent or temporary that may be caused by the use of any
battery.
Indy Vapor Shop is not responsible for any device
malfunctioning due to use by an inexperienced vaper who does not have the
knowledge and understanding of how to use, and properly rebuild advanced
e-cigarette devices.
Please have a basic understanding of the batteries
you are using and how to care for them properly. Read the information found at:
Battery
University before purchasing.
It is important to carry batteries properly,
recharge properly, and dispose properly.
Since we have no control over how a buyer uses the
product; no guarantee, warranty, or return privilege will apply. The
manufacturer may offer a limited warranty. Buyer shall be responsible for
returning the product to the manufacturer. We regret having to strictly enforce
this policy. The use of DIY liquid, improper chargers, modified atomizers, and
general abuse of the product has made it necessary.
Please do not order if you do not understand
and accept these terms.